wiring century pool motor replacement instructions

Replacing a pool motor can be a daunting task for the average homeowner. It's not only a difficult job, but it can also be dangerous if done incorrectly. Thankfully, with the right guidance and the proper safety precautions, you can easily wire a new century pool motor with confidence. This article will provide step-by-step instructions to walk you through the wiring process.

The first thing you’ll need to do is turn off your circuit breaker and unplug the motor from the ground fault circuit interrupter (GFCI). Then, disconnect the existing motor wires, which are usually red and black, from the switch box. Next, you'll want to install the new motor and ensure it is properly grounded by attaching the grounding wires from the motor to the green screw on the side of the motor.

Once the motor is installed, it’s time to connect the wires. You'll need to attach the black wire from the switch box to the black terminal of the motor, and the red wire from the switch box to the red terminal of the motor. You should also use a twist-on wire connector to connect the white wire from the motor to the neutral wire in the switch box. Finally, you'll want to check the wiring diagram of your motor, then attach the appropriate color wire to the other terminals based on the diagram.

When you’ve finished wiring the motor, you’re ready to restore power. Turn the circuit breaker back on and plug the motor into the GFCI. Be sure to test the motor operation before installing the motor cover. With these tips, you can now safely and confidently replace your century pool motor.

What Size Breaker Can I Use For This Pool Pump Motor Mike Holt S Forum